Suction Holder with Manual Pump

This suction holder is ideal for mounting end products. Diverse components can be attached to the threaded pin (1/4“) in order to carry out measurements, e.g. cameras. The red ring at the pump tappet guarantees highest safety through visual monitoring of the vacuum. An adaptor from ¼” thread to M6 (BO 6024) or from ¼” thread to M8 (BO 6023) can be ordered separately if required.

Technical Data:

Load capacity 39,6 lbs (18 kg)
Suction pad ø 4-1/2 in (ø 115 mm)
Type of vacuum generation Pump-Activated Suction Lifters
Type of fastening 1/4" Thread
Material Plastic
Surface geometry flat
Torque – Nm
Vacuum gauge yes
GS certified no
Loading additional product information...