Point Fixings and Standoffs

Name plates or guidance systems are found everywhere in our daily lives. In this chapter you will find a selection of sophisticated, high-quality stainless steel holders for name plates and guidance systems made of glass. This range is especially suitable for large interior installations.

Name plates or guidance systems are found everywhere in our daily lives. In this chapter you will find a selection of sophisticated, high-quality stainless steel holders for name plates and... read more »
Close window
Point Fixings and Standoffs

Name plates or guidance systems are found everywhere in our daily lives. In this chapter you will find a selection of sophisticated, high-quality stainless steel holders for name plates and guidance systems made of glass. This range is especially suitable for large interior installations.

14 Product(s)
Close filters
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
1 From 2
No results were found for the filter!
GM PICO Single Point Fixings with black cover cap GM PICO Single Point Fixings with black cover cap
For flush mounting of mirror or glass elements indoors
Side Connector  glass/glass 180° Side Connector glass/glass 180°
Glass thickness tempered glass 25/64" - 15/32" (10 - 12 mm) Width glass-to-glass 3 mm
Single Point Fixings Single Point Fixings
Glass thickness tempered glass 25/64" - 15/32" (10 - 12 mm) Suitable drill BO 5000626
Corner Clamp glass/wall 90° Corner Clamp glass/wall 90°
Drill hole in glass ø9/16" (ø14 mm) Glass thickness 1/4" - 5/16" (6 - 8 mm)
Corner Clamp glass/glass 90° Corner Clamp glass/glass 90°
Drill hole in glass ø9/16" (ø14 mm) Glass thickness 1/4" - 5/16" (6 - 8 mm) for inner corner
Corner Clamp glass/wall 90° Corner Clamp glass/wall 90°
Drill hole in glass ø5/8" (ø16 mm) Glass thickness 5/16" - 25/64" (8 - 10 mm)
Corner Clamp glass/glass 90° Corner Clamp glass/glass 90°
Drill hole in glass ø5/8" (ø16 mm) Glass thickness 5/16" - 25/64" (8 - 10 mm) for inner corner
Single Point Fixings Single Point Fixings
Glass thickness 1/4 - 3/5 in (6 - 12 mm) Wall mounting by M5 countersunk screw The load capacity of the standoff greatly depends on the physical properties of the mounting substrate as well as the choice of suitable mounting...
Circlip Pliers  for Single Point Fixings Circlip Pliers for Single Point Fixings
Modell Knipex® 4611A1 for removing the cover caps
1 From 2
Recently viewed